Skip to content
MyBYD Search MyBYD
Menu

MODEL-MATCHED · EQUIPMENT DEPENDENT

Power an appliance.
Start with the right source.

V2L means vehicle-to-load: electricity from your car through the compatible discharge equipment. This focused reference is not a compatibility guarantee or a complete operating procedure.

BYD ATTO 3

RHD 07.2024 EN_V4 · Reviewed 7 October 2026

Match the edition, vehicle equipment and discharge adapter to your car. Read the full discharging section and its linked charging-safety precautions before use.

01 · EQUIPMENT & LOAD

What power limit applies?

No AC appliance-output ceiling has been established from these reviewed pages for your exact adapter. Do not substitute a limit from another BYD model. Confirm the vehicle and adapter limits with BYD and check the adapter’s rating and instructions.

Check the appliance’s requirements, including starting demand, against the compatible equipment. There is no kettle/air-fryer compatibility calculator here.

02 · BEFORE USE

Battery level is only one condition

The selected edition requires at least 15% battery state of charge before discharging. It recommends using V2L at a high charge level and warns of restricted operation at low charge.

This is a pre-use condition, not a verified automatic cut-off setting. Allow for the driving range you still need.

Keep the load switched off before starting. Do not use damaged equipment, or a port with water, foreign material, damaged terminals or corrosion. Follow the full source checks and connection sequence.

03 · IMPORTANT WARNINGS

Read before connecting

Do not touch the metal terminals during discharge. Stop immediately if there is unusual smell, smoke or another abnormality. Protect the equipment from being driven over, dropped or trampled on; keep it away from the boot, beneath the vehicle’s front and the tyres during use.

The handbook’s charging-equipment precautions also apply. These selected warnings do not replace the complete safety instructions.

04 · FINISHING

Your model’s stopping instructions

The handbook’s sequence disconnects the load before removing the discharge equipment, then closes the port and stores the equipment. Read the exact source for unlocking and equipment-specific controls; do not force a locked connector.

Not a home-power installation guide

This page does not provide household wiring, V2H installation, DC equipment setup or a guaranteed runtime. It needs an internet connection and is not silently added to Pocket Companion.

Full handbook → · My Garage →
Share this page

Help another BYD driver.

WhatsAppFacebookEmailText messageNothing is sent until you choose a recipient and confirm in your app. Sharing services have their own privacy policies.